Анализ несущих конструкций 19-дюймовой и метрической систем для электронных средств
Анотація
Проведено исследование и анализ различных показателей качества несущих конструкций двух конструкционных систем для определения их характеристик и сравнения между собой, а также прогнозирования перспектив их дальнейшего использования.
Посилання
IEC 60297-3-106. Mechanical structures for electronic equipment — Dimensions of mechanical structures of the 482.6 mm (19 in) series — Part 3-106: Adaptation dimensions for subracks and chassis applicable with metric cabinets or racks in accordance with IEC 60917-2-1.
Anisimov O.Yu., Tokarenko L.D. Tekhnologiya i konstruirovanie v elektronnoi apparature, 1997, nо. 1, рр. 15-19. (Rus)
IEC 60297-3-101(2004) Mechanical structures for electronic equipment - Dimensions of mechanical structures of the 482.6 mm (19 in) series — Part 3-101: Subracks and associated plug-in units.
IEC 60917-2-2(1994). Modular order for the development of mechanical structures for electronic equipment practices — Part 2: Sectional specification; interface co-ordination dimensions for the 25 mm equipment practice; section 2: Detail specification; dimensions for subracks, chassis, backplanes, front panels and plug-in units.
Yefimenko A.A., Karlangach A.P., Lazarev S. N. Tekhnologiya i konstruirovanie v elektronnoi apparature, 2014, nо. 5-6, рр. 3-9. (Rus)
IEC 60297-3-100:2008. Mechanical structures for electronic equipment. Dimensions of mechanical structures of the 482.6 mm (19 in) series. Part 3-100: Basic dimensions of front panels, subracks, chassis, racks and cabinets.
IEC 60917-1:1998. Modular order for the development of mechanical structures for electronic equipment practices. Part 1: Generic standard.
IEC 60603-2:1995, Connectors for frequencies below 3 MHz for use with printed boards — Part 2: Detail specification for two-part connectors with assessed quality, for printed boards, for basic grid of 2.54 mm (0,1 in) with common mounting features.
IEC 61076-4-100:2001. Connectors for electronic equipment. Part 4-100. Printed board connectors with assessed quality. Detail specification for two-part connector modules having a grid of 2.5 mm for printed boards and backplanes.
IEC 61076-4-101:2001. Connectors for electronic equipment. Part 4-101: Printed board connectors with assessed quality. Detail specification for two-part connector modules, having a basic grid of 2.0 mm for printed boards and backplates in accordance with IEC 60917.
Авторське право (c) 2015 Ефименко А. А., Карлангач А. П.
Ця робота ліцензується відповідно до Creative Commons Attribution 4.0 International License.
