Milling and engraving plotters for printed circuit board fabrication

  • E. M. Kudryavtsev SKB VNIIOFI, Smolensk, Russia
Keywords: printed circuit board, milling, engraving, plotter

Abstract

The advantages of the milling and engraving method of printed circuit board production over the traditional etching method are demonstrated in the context of rapid manufacturing of small batches of boards (1–100 units). Technical and cost characteristics of a domestic plotter—both currently manufactured and prospective—are presented.

Published
2005-02-28
How to Cite
Kudryavtsev, E. M. (2005). Milling and engraving plotters for printed circuit board fabrication. Technology and Design in Electronic Equipment, (1), 51-52. Retrieved from https://www.tkea.com.ua/index.php/journal/article/view/TKEA2005.1.51
Issue
No. 1 (2005): Tekhnologiya i konstruirovanie v elektronnoi apparature
Section
Articles

Copyright (c) 2005 Kudryavtsev E. M.

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.