Determination of power and weight-and-size parameters of passive components of pulsed converters

  • A. M. Afanasyev Donbas State Technical University, Alchevsk, Ukraine
  • A. V. Ereminа Donbas State Technical University, Alchevsk, Ukraine
Keywords: pulsed converter, passive components, power loss, mass and dimensions, current ripple factor, switching frequency

Abstract

The paper presents a method for calculating the loss power and weight of passive elements of pulsed converters (PC) depending on the coefficient of the current ripple in the storage inductor and the frequency of switching. The method allows to optimize power and weight-and-size parameters, as well as the PC modes. The curves obtained using the proposed method are presented. The analysis of these curves allows to determine the conditions for minimum loss power and weight of passive components of PCs.

Published
2013-10-14
How to Cite
Afanasyev, A. M., & EreminаA. V. (2013). Determination of power and weight-and-size parameters of passive components of pulsed converters. Technology and Design in Electronic Equipment, (5), 13-19. Retrieved from http://www.tkea.com.ua/index.php/journal/article/view/TKEA.2013.5.13
Issue
No. 5 (2013): Tekhnologiya i konstruirovanie v elektronnoi apparature
Section
Articles

Copyright (c) 2013 Afanasyev A. M., Ereminа A. V.

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.